Instant Heating Electric Tap Water Heater Fittings Kitchen Fittings De
Product Information
Stainless Steel Instant Water Heater Faucet
The faucet with instant water heater has a bottom water inlet and a 1/2-inch interface. During installation, the faucet can only be installed upright, and the water pressure requirement is 0.04~0.05 MPa. Heating range: 30-60°C. Voltage: 220V, Power: 3000W.
Easy to Use
Our electric instant water heaters have undergone rigorous testing. The electrical and fluid systems are completely separated to prevent electrical leaks and water pipe corrosion. Note: The faucet must be run through water before use and cannot be subjected to dry burning.
Easy to Use
The extendable brass tube is seamlessly connected and does not leak. At the same time, it can be extended 360 degrees as desired. The instantaneous water heater uses an LED display that intuitively detects temperature changes. The data is accurate, convenient, and fast, making it suitable for family use.
Caution:
1. Please turn on the cold water before turning on the power. It is strictly forbidden to use water purifiers, water filter faucets, etc. During installation, the original accessories must be blocked to prevent the machine from overheating and damaging the unit.
2. Before installation, be sure to connect the water supply first and then turn it on. The product must be installed vertically and upwards; do not install it side by side, upside down, or horizontally.
3. Please be careful in the following two situations:
1. Users who use low-pressure areas or water towers, or who live in high- and low-pressure areas.
2. Old-style houses. The wires in the house are very old. The wire is too thin to cover 2 square meters.
4. The machine is started by water pressure. Users who are not exposed to tap water, water tanks, or water towers, or whose water pressure is too low (the water tank and water tower drop is less than 6 meters) are not recommended to purchase it.
4. Each product undergoes layer-by-layer testing before shipment, including heating tests, anti-leakage tests, and anti-leakage tests. It is normal for residual water droplets to remain in the cavity after receiving the product.
Note: The lower the water flow, the higher the temperature.